Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 460

distance bgp Configure three administrative distances for routes. C9000 Series Syntax distance bgp external-distance internal-distance local-distance To return to default values, use the no distance bgp command. Parameters external-distance internal-distance local-distance Enter a number to assign to routes learned from a neighbor external to the AS. The range is from 1 to 255. The default is 20. Enter a number to assign to routes learned from a router within the AS. The range is from 1 to 255. The default is 200. Enter a number to assign to routes learned from networks listed in the network command. The range is from 1 to 255. The default is 200. Defaults • external-distance = 20 • internal-distance = 200 • local-distance = 200 Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.7.0 7.8.1.0 7.7.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information CAUTION: Dell Networking recommends not changing the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. Related Commands router bgp - enters ROUTER mode on the switch. Border Gateway Protocol 460