Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1890

Save the configuration and reload the system for the delay timers to take effect. Related Command vrrp delay minimum - sets the delay time for VRRP initialization after a line card reboot. vrrp-group Assign a VRRP ID to an interface. You can configure up to 255 VRRP groups per interface. C9000 Series Syntax Parameters vrrp-group vrrp-id vrrp-id Enter a number as the group ID. The range is from 1 to 255. Defaults Not configured. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. Related Command virtual-address - assigns up to 12 virtual IP addresses per VRRP group. track Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled. C9000 Series Syntax track interface [priority-cost cost] To disable monitoring, use the no track interface command. Virtual Router Redundancy Protocol (VRRP) 1890