Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 793

linecard portmode Split a single 40G port into four 10G ports on the switch. C9000 Series Syntax Parameters linecard slot-id port number portmode quad linecard slot-id number Enter the slot ID of a line card to reset. The range of slot IDs is from 0 to 11. Enter the port number of the 40G port to be split. The port range is from 0 to 20. A 40G port number is a multiple of 4; for example, 0, 4, 8, 12, ... 120, 124, 128). Defaults Disabled. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) Description Introduced on the C9010. Introduced on the Z9500. Usage Information Enabling quad mode on a port removes the interface configurations (if any) on the port after a save and reload. Be sure that the port is removed from other L2 and L3 feature configurations. You must save and reload the system for the 40G to 4x10G port change to take effect. This command cannot be used if LR4 optics are inserted in the 40G port. monitor interface Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five seconds and the CLI prompt disappears. C9000 Series Syntax monitor interface [interface] [linecard slot-id] To disable monitoring and return to the CLI prompt, press the q key. Parameters interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For the management port, enter the keyword managementethernet then the slot (0 or 1) and the port (0). Interfaces 793