Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1485

• show interfaces private-vlan - displays the type and status of the PVLAN interfaces. • show vlan private-vlan - displays the PVLANs and/or interfaces that are part of a PVLAN. • switchport mode private-vlan - sets PVLAN mode of the selected port. private-vlan mode Set PVLAN mode of the selected VLAN to community, isolated, or primary. C9000 Series Syntax [no] private-vlan mode {community | isolated | primary} To remove the PVLAN configuration, use the no private-vlan mode {community | isolated | primary} command syntax. Parameters community isolated primary Enter the keyword community to set the VLAN as a community VLAN. Enter the keyword isolated to configure the VLAN as an isolated VLAN. Enter the keyword primary to configure the VLAN as a primary VLAN. Defaults none Command Modes INTERFACE VLAN Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series and S-Series. Usage Information The VLAN: • can be in only one mode, either community, isolated, or primary. • mode ode to community or isolated even before associating it to a primary VLAN. This secondary VLAN continues to work normally as a normal VLAN even though it is not associated to a primary VLAN. (A syslog message shows this information.) • must not have a port in it when VLAN mode is being set. Only ports (and port channels) configured as promiscuous, host, or PVLAN trunk ports (as previously described) can be added to the PVLAN. No other regular ports can be added to the PVLAN. Private VLAN (PVLAN) 1485