Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 53

INTERFACE Mode Use INTERFACE mode to configure interfaces or IP services on those interfaces. An interface can be physical (for example, a 10-Gigabit Ethernet port) or virtual (for example, the Null interface). To enter INTERFACE mode: 1. Verify that you are logged in to CONFIGURATION mode. 2. Enter the interface command and then enter an interface type and interface number that is available on the switch. The prompt changes to include the designated interface and slot/port number. For example: Prompt Interface Type Dell(conf-if)# INTERFACE mode Dell(conf-if- Ten-Gigabit Ethernet interface then slot/port information te-0/0)# Dell(conf-if- Forty-Gigabit Ethernet interface then slot/port information fo-0/0)# Dell(conf-if- Loopback interface number lo-0)# Dell(conf-if- Null Interface then zero nu-0)# Dell(conf-if- Port Extender Gigabit Ethernet interface then pe-id/stack-unit/ port-id information. pegi-0/0/1)# Dell(conf-if- Port-channel interface number po-0)# Dell(conf-if- VLAN Interface then VLAN number (range 1-4094) vl-0)# Dell(conf-if- Management Ethernet interface then slot/port information ma-0/0)# Dell(conf-if- Tunnel interface then tunnel ID. tu-0)# Dell(conf-if- Designated interface range (used for bulk configuration). range)# IP ACCESS LIST Mode To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip accesslist standard or ip access-list extended command. To enter IP ACCESS LIST mode: 1. Verify that you are logged in to CONFIGURATION mode. 2. Use the ip access-list standard or ip access-list extended command. Include a name for the ACL. The prompt changes to include (conf-std-nacl) or (conf-ext-nacl). You can return to CONFIGURATION mode by using the exit command. CLI Basics 53