Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1518

Version 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 7.5.1.0 7.4.1.0 6.1.1.1 Description Introduced on the Z9000. Introduced on the S4810. Policy name character limit increased from 16 to 32. Introduced on the S-Series. Introduced on the C-Series. Expanded to add support for Layer 2. Introduced on the E-Series. Usage Information The input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or incoming packets DSCP. This command enables Policy-Map-Input Configuration mode (conf-policymap-in). When you configure an input policy map for CoPP, you must enter the keyword cpu-qos. Use this command in Configuration Terminal Batch mode to create an input policy map in a dualhoming setup. Related Commands service-queue - assigns a class map and QoS policy to different queues. policy-aggregate - allows an aggregate method of configuring per-port QoS using policy maps. service-policy input - applies an input policy map to the selected interface. policy-map-output Create an output policy map. C9000 Series Syntax policy-map-output policy-map-name To remove a policy map, use the no policy-map-output policy-map-name command. Parameters policy-map-name Enter the name for the policy map in character format (32 characters maximum). Defaults none Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Quality of Service (QoS) 1518