Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1146

show lldp neighbors Display LLDP neighbor information for all interfaces or a specified interface. C9000 Series Syntax show lldp neighbors [interface] [detail] From a PE console, use show lldp neighbors to view the LLDP neighbor information. Parameters interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information. • For a Management Ethernet interface, enter the keyword managementethernet then the slot/port information.. • For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48. • For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet then the slot/port information. detail (OPTIONAL) Enter the keyword detail to display all the TLV information, remote management IP addresses, timers, and LLDP tx and rx counters. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.1.(0.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Description Introduced on the C9010 and C1048P. Introduced on the Z9500. Modified output of detail parameter to display remote management IP addresses. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Link Layer Discovery Protocol (LLDP) 1146