Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 933

• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. vrf vrf-name (OPTIONAL) Enter the keyword vrffollowed by the name of the VRF to display adjacent router information corresponding to that VRF Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.5(0.1) 9.0.2.0 8.3.19.0 8.3.12.0 8.3.11.1 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Added support for VRF. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Usage Information Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are not, you can verify the specified area addresses of the routers by using the show isis neighbors command. The following describes the show isis neighbors command shown in the following example. Field Description System Id The value that identifies a system in an area. Interface The interface, slot, and port in which the router was discovered. State The value providing status about the adjacency state. The range is Up and Init. Type This value displays the adjacency type (Layer 2, Layer 2 or both). Priority IS-IS priority the neighbor advertises. The neighbor with highest priority becomes the designated router for the interface. Uptime Displays the interfaces uptime. Circuit Id The neighbor's interpretation of the designated router for the interface. Example The bold sections below identify that Multi-Topology IS-IS is enabled. This command displays only one IP address per line. Dell#show isis neighbors System Id Interface State Type Priority Uptime Circuit Id TEST Gi 7/1 Up L1L2(M) 127 09:28:01 TEST.02 ! Dell#show isis neighbors detail System Id Interface State Type Priority Uptime Circuit Id TEST Gi 7/1 Up L1L2(M) 127 09:28:04 TEST.02 Area Address(es): Intermediate System to Intermediate System (IS-IS) 933