Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1018

Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.7.0 8.1.1.0 7.9.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced VRF on the E-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell>show ip fib linecard 2 Destination Gateway First-Hop Addr Port VId EC 1.1.32.140/32 via 1.1.32.140, PeGigE PE‐ID/Slot/Port 1.1.32.140 00:00:00:00:1f:8a PeGigE PE‐ID/Slot/Port 200 0 Mac- show ip flow Show how a Layer 3 packet is forwarded when it arrives at a particular interface. C9000 Series Syntax Parameters show ip flow interface interface {source-ip address destination-ip address} {protocol number [tcp | udp]} {src-port number destination-port number} interface interface Enter the keyword interface then one of the following interface keywords. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. source-ip address destination-ip address protocol number [tcp | udp] src-port number Enter the keywords source-ip then the IP source address in IP address format. Enter the keywords destination-ip then the IP destination address in IP address format. Enter the keyword protocol then one of the protocol type keywords: tcp, udp, or protocol number The protocol number range is from 0 to 255. . Enter the keywords src-port then the source port number. IPv4 Routing 1018