Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1296

show ip ospf neighbor Display the OSPF neighbors connected to the local router. C9000 Series Syntax Parameters show ip ospf [process-id |vrf vrf-name] neighbor process-id vrf vrf-name Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Enter the keyword vrf and the name of the VRF to view information corresponding to the OSPF neighbors that are tied to a specific VRF. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.4(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Added support for VRF on all platforms (Except MXL and STOMP). Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ip ospf process-id neighbor command shown in the following example. Item Description Neighbor ID Displays the neighbor router ID. Pri Displays the priority assigned neighbor. State Displays the OSPF state of the neighbor. Dead Time Displays the expected time until the system declares the neighbor dead. Address Displays the IP address of the neighbor. Interface Displays the interface type slot/port information. Area Displays the neighbor's area (process ID). Open Shortest Path First (OSPFv2 and OSPFv3) 1296