Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1899

Version 9.5(0.0) 9.4.(0.0) Description Introduced on the Z9500. Introduced on the S-Series. Usage Information Use this command to specify a descriptive name for a VRF. ip vrf forwarding Attach an interface to a configured VRF. C9000 Series Syntax ip vrf forwarding {vrf-name | management} To delete an interface associated with a configured VRF, use the no ip vrf forwarding {vrf-name | management} command. Parameters vrf-name management Enter name of the VRF that you want to associate the interface to. Use this keyword when you want to associate the interface to the management VRF. Defaults None (Interface is part of default VRF). Command Modes INTERFACE-CONFIG Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.4.(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON and Z9500. Introduced on the S-Series and Z9000. Usage Information Use this command to attach an interface to a configured VRF. You can attach an interface to either a non-default VRF or a management VRF. To assign a port-back to a default VRF, remove VRF association from the interface. You can use this only if there is no IP address configured on the interface. There must be no prior Layer 3 configuration on the interface when configuring VRF. VRF must be enabled prior to implementing this command. You can configure an IP subnet or address on a physical or VLAN interface that overlaps the same IP subnet or address configured on another interface only if the interfaces are assigned to different VRFs. If two interfaces are assigned to the same VRF, you cannot configure overlapping IP subnets or the same IP address on them. Virtual Routing and Forwarding (VRF) 1899