Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1888

Version 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 7.4.1.0 6.2.1.1 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced support for telnetting to the VRRP group IP address assigned using this command. Introduced on the E-Series. Usage Information The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with the same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual addresses configured in all VRRP groups. vrrp delay minimum Set the delay time for VRRP initialization after an interface comes up. C9000 Series Syntax Parameters vrrp delay minimum seconds seconds Enter the number of seconds for the delay for VRRP initialization after an interface becomes operational. The range is from 0 to 900 (0 indicates no delay). Defaults 0 Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.0.0.0 8.3.19.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S4820T. Virtual Router Redundancy Protocol (VRRP) 1888