Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1901

ip route-import Import IPv4 routes leaked by another VRF using the tag specified by that VRF during route-export process. C9000 Series Syntax Parameters ip route-import tag [route-map-name] route-import tag Enter the keyword route-import to import routes into the VRF. Enter a tag (ASN number) to specify an import route target for importing routes from another VRF. To import leaked routes from another VRF, you must use the same ASN number that is specified as the export route target at the source VRF. route-map-name Enter the name of the route-map to filter the imported routes. NOTE: You must use the route-map attribute while importing routes from the global RTM. Route-maps enable you to filter routes at the import end based on the matching criteria that you define in the route-map. Defaults Command Modes Not configured. • CONFIGURATION • VRF MODE Command History Version 9.9(0.0) 9.8(0.0) 9.7(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500. Usage Information You can configure multiple import conditions per VRF depending on the exporting VRF. The export-target and import-target support only the match protocol and match prefix-list options, all other options configured in the route-map are ignored. Related Commands ip route-export - exports routes to another VRF. ipv6 route-export Enable route leaking between VRFs. Export or share IPv6 routes corresponding to one VRF with other non-default VRFs. C9000 Series Syntax ipv6 route-export tag [route-map-name] Virtual Routing and Forwarding (VRF) 1901