Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1139

• For a Management Ethernet interface, enter the keyword managementethernet then the slot/port information. • For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. debug lldp interface To display timer events, neighbor additions or deletions, and other information about incoming and outgoing packets, enable LLDP debugging. C9000 Series Syntax debug lldp interface {interface | all}{events | packet {brief | detail} {tx | rx | both}} To disable debugging, use the no debug lldp interface {interface | all}{events} {packet {brief | detail} {tx | rx | both}} command. Parameters interface Enter the following keywords and slot/port or number information: • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information. • For a Management Ethernet interface, enter the keyword managementethernet then the slot/port information.. • For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; Link Layer Discovery Protocol (LLDP) 1139