Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 524

mask route-map mapname Enter the mask of the IP address in the slash prefix length format (for example, / 24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keywords route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version Description 9.9(0.0) Introduced on the C9010. 9.2(1.0) Introduced on the Z9500. 8.2.1.0 Introduced on the E-Series ExaScale. 7.4.1.0 Introduced Usage Information The software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. Related Commands redistribute - redistributes routes into BGP. network backdoor Specify this IGP route as the preferred route. C9000 Series Syntax network ipv6-address prefix-length backdoor To remove a network, use the no network ipv6-address prefix-length backdoor command. Parameters ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. The r range is /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros. Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Border Gateway Protocol 524