Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1478

Example Version 9.0.2.0 8.3.19.0 8.3.7.0 8.3.11.1 8.1.1.0 7.7.1.0 7.5.1.0 7.4.1.0 Description Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Dell(conf-mon-sess-2)#show config ! monitor session 2 type rpm source fortyGigE 0/60 destination remote-vlan 300 direction rx source Port-channel 10 destination remote-vlan 300 direction rx no disable Dell# show monitor session Display port extender (PE) Gigabit Ethernet interface monitoring information. C9000 Series Syntax show monitor session {session-ID} To display monitoring information for all sessions, use the show monitor session command. To display monitoring information for port extender interface, when added as a source port, use the do show monitor session command in CONFIGURATION mode. Parameters session-ID (OPTIONAL) Enter a session identification number. The range is from 0 to 65535. Defaults Command Modes none • CONFIGURATION • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) Description Introduced on the C9010. Introduced on the Z9500. Port Monitoring 1478