Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 398

If the AS-PATH access list is not configured, the default is permit (allow routes). in Enter the keyword in to filter inbound BGP routes. out Enter the keyword out to filter outbound BGP routes. Defaults Not configured. Command Modes • ROUTER BGP • ROUTER BGP-address-family Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 7.8.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S-Series. Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, ACL names were up to 16 characters long. 7.7.1.0 Introduced on the C-Series. Usage Information To enter AS-PATH ACL mode and configure the AS-PATH filters to deny or permit BGP routes based on information in their AS-PATH attribute, use the ip as-path access-list command in CONFIGURATION mode. Related Commands ip as-path access-list - enter AS-PATH ACL mode and configure the AS-PATH filters. neighbor graceful-restart Enable graceful restart on a BGP neighbor. C9000 Series Syntax neighbor {ip-address | peer-group-name} graceful-restart [restart-time seconds] [stale-path-time seconds] [role receiver-only] To return to the default, enter the no bgp graceful-restart command. Parameters ip-address Enter the IP address of the neighbor in dotted decimal format. peer-group-name Enter the name of the peer group to apply the filter to all routers in the peer group. Border Gateway Protocol 398