Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 420

Parameters connected static Enter the keyword connected to redistribute routes from physically connected interfaces. Enter the keyword static to redistribute manually configured routes. These routes are treated as incomplete routes. route-map mapname (OPTIONAL) Enter the keyword route-map then the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 7.8.1.0 7.7.1.0 Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced the ability to substitute IGP cost for MED when a peer/peer-group outbound route-map is set as internal. Introduced on the S-Series. Introduced on the C-Series. Usage Information You can use the redistribute command to advertise the IGP cost as the MED on redistributed routes. When you set the route-map with metric-type internal and applied outbound to an EBGP peer/peergroup, the advertised routes corresponding to those peer/peer-groups have the IGP cost set as MED. Border Gateway Protocol 420