Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1012

dynamic summary (OPTIONAL) Enter the keyword dynamic to display dynamically-learned ARP entries. (OPTIONAL) Enter the keyword summary to view a summary of ARP entries. Default Display only the ARP entries learned on the Control Processor. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 8.2.1.0 8.1.1.0 7.9.1.0 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Added support for 4094 VLANs on the E-Series ExaScale (the prior limit was 2094). Introduced on the E-Series ExaScale. Introduced VRF on the E-Series. Augmented to display local ARP entries learned from private VLANs (PVLANs). Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Use the show arp command to display the ARP entries learned on the Control Processor and Route Processor. The following example shows two VLANs that are associated with a private VLAN (PVLAN) (refer to Private VLAN (PVLAN)). The following describes the show arp command shown in the following example. Field Description Protocol Displays the protocol type. Address Displays the IP address of the ARP entry. Age(min) Displays the age (in minutes) of the ARP entry. Hardware Address Displays the MAC address associated with the ARP entry. Interface Displays the first two letters of the interfaces type and the slot/port associated with the ARP entry. VLAN Displays the VLAN ID, if any, associated with the ARP entry. CPU Lists which CPU the entries are stored on. IPv4 Routing 1012