Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1446

discard Use the discard command to cancel the uncommitted changes made to common configurations in the Configuration Terminal Batch mode. C9000 Series Syntax discard Default None Command Modes CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) Description Introduced on the C9010. Usage Information The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in a dual-homing environment. Use the discard command to cancel the uncommitted common configuration changes. Example The following example shows the configurations being discarded: Dell(conf-b)#interface vlan 2000 Dell(conf-b-if-vl-2000)#tagged peGigE 184/0/1 Dell(conf-b-if-vl-2000)#show config interface vlan 2000 tagged peGigE 184/0/1 Dell(conf-b-if-vl-2000)#discard Dell(conf-b)#show config Dell(conf-b)#exit Dell# import peer-config Use import peer-config to import the common configurations from the peer chassis. C9000 Series Syntax Default Command Modes import peer-config None EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. Port Extenders (PE) 1446