Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1502

Parameters To delete the IEEE 802.1p configuration on the interface, use the no dot1p-priority command. priority-value Enter a value from 0 to 7. dot1p Queue Number 0 1 1 0 2 2 3 3 4 4 5 5 6 6 7 7 Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.5.1.0 6.1.1.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series. Introduced on the E-Series. Usage Information The dot1p-priority command changes the priority of incoming traffic on the interface. The system places traffic marked with a priority in the correct queue and processes that traffic according to its queue. When you set the priority for a port channel, the physical interfaces assigned to the port channel are configured with the same value. You cannot assign the dot1p-priority command to individual interfaces in a port channel. Quality of Service (QoS) 1502