Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 466

Parameters extended community list name Enter the name of the extended community list. Defaults none Command Modes ROUTE MAP (config-route-map) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 7.8.1.0 7.7.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Like standard communities, you can use extended communities in the route-map to match the attribute. Example Dell(config-route-map)#match extcommunity Freedombird Dell(config-route-map)# permit To add rules (permit) from the two types of extended communities, Route Origin (rt) or Site-of-Origin (soo), use this feature. C9000 Series Syntax permit {rt | soo} {as4 ASN4:NN | ASN:NNNN | IPADDR:NN} To change the rules, use the no permit {rt | soo} {as4 ASN4:NN | ASN:NNNN | IPADDR:NN} command. Parameters Defaults rt soo as4 ASN4:NN ASN:NNNN IPADDR:NN Not configured. Enter the keyword rt to designate a Route Origin community. Enter the keyword soo to designate a Site-of-Origin community (also known as Route Origin). Enter the keyword as4 then the 4-octet AS specific extended community number in the format ASN4:NN (4-byte AS number:2-byte community value). Enter the 2-octet AS specific extended community number in the format ASN:NNNN (2-byte AS number:4-byte community value). Enter the IP address specific extended community in the format IPADDR:NN (4byte IPv4 Unicast Address:2-byte community value). Border Gateway Protocol 466