Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 86

Parameters To delete an interface, use theno ip http source-interface interface command. interface Enter the following keywords and slot/port or number information: • For Loopback interfaces, enter the keyword loopback then a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel then a number. The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. • For a tunnel interface, enter the keyword tunnel. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.3(0.1) 8.3.11.1 8.2.1.0 8.1.1.0 7.6.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the Z9000 Increased number of VLANs on ExaScale to 4094 (was 2094) Introduced on E-Series ExaScale Support added for S-Series Introduced on C-Series ip telnet server enable Enable the Telnet server on the switch. C9000 Series Syntax ip telnet server enable To disable the Telnet server, use the no ip telnet server enable command. Defaults Enabled Command Modes CONFIGURATION Control and Monitoring 86