Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 74

Proceed with reload [confirm yes/no]: n Dell(conf-if-te-5/0)# enable Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a password. C9000 Series Syntax enable [level] From a PE console, use enable [level] to enter EXEC privilege mode . Parameters level (OPTIONAL) Enter a number for a privilege level of Dell Networking OS. The range is from 0 to 15. Defaults 15 Command Modes EXEC Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.5(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.6.1.0 7.5.1.0 E-Series Description Introduced on the C9010 and C1048P. Added support for roles on the Z9500. Added support for roles on the Z9000, S6000, S4820T, S4810, MXL Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Original command. Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands. To protect against unauthorized access, use the enable password command to configure a password for the enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15. You can also use the enable [level] command from a PE console to enter the privileged mode. Control and Monitoring 74