Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 946

ip igmp querier-timeout Change the interval that must pass before a multicast router decides that there is no longer another multicast router that should be the querier. C9000 Series Syntax ip igmp querier-timeout seconds To return to the default value, use the no ip igmp querier-timeout command. Parameters seconds Enter the number of seconds the router must wait to become the new querier. The range is from 60 to 300. The default is 125 seconds. Defaults 125 seconds Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.5(0.1) 9.2(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.6.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the S-Series in Interface VLAN mode only to enable the system to act as an IGMP Proxy Querier. Introduced on the C-Series in Interface VLAN mode only to enable the system to act as an IGMP Proxy Querier. Internet Group Management Protocol (IGMP) 946