Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1903

tag route-map-name Enter a tag (ASN number) to specify an import route target for importing routes from another VRF. To import leaked routes from another VRF, you must use the same ASN number that is specified as the export route target at the source VRF. Enter the name of the route-map to filter the imported routes. NOTE: You must use the route-map attribute while importing routes from the global RTM. Route-maps enable you to filter routes at the import end based on the matching criteria that you define in the route-map. Command Modes VRF MODE CONFIGURATION Command History Version 9.9(0.0) 9.8(0.0) 9.7(0.0) Description Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, and Z9500. Usage Information It is possible to configure multiple import conditions per VRF depending on the exporting VRF. The export-target and import-target support only the match protocol and match prefix-list options. Other options that are configured in the route-maps are ignored. Related Commands ipv6 route-export - exports IPv6 routes to another VRF. match source-protocol Specify matching criteria while exporting or importing routes. C9000 Series Syntax Parameters match source-protocol {bgp | isis | ospf | connected | static} bgp isis ospf connected static Enter the keyword bgp to leak or share routes corresponding to the BGP protocol. Enter the keyword isis to leak or share routes corresponding to the ISIS protocol. Enter the keyword ospf to leak or share routes corresponding to the OSPF protocol. Enter the keyword connected to leak or share connected routes corresponding to the VRF. Enter the keyword static to leak or share static routes corresponding to the VRF. Command Modes ROUTE MAP MODE Command History Version Description 9.9(0.0) Introduced on the C9010. Virtual Routing and Forwarding (VRF) 1903