Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1914

Version 8.2.1.0 8.2.1.0 7.6.1.0 Description Introduced on the E-Series ExaScale. C-Series and S-Series accept both bytes of the 2-byte S-Tag TPID. Introduced on the E-Series ExaScale. Introduced on the C-Series and S-Series. Usage Information For specific interoperability limitations regarding the S-Tag TPID, see the Dell Networking OS Configuration Guide. The four characters you enter in the CLI for number are interpreted, as shown in the following table. Number 1 10 81 8100 Resulting TPID 0x0001 0x0010 0x0081 0x8100 Related Commands • portmode hybrid - sets a port (physical ports only) to accept both tagged and untagged frames. A port configured this way is identified as a hybrid port in report displays. • vlan-stack trunk - specifies a Layer 2 port or port channel as a trunk port to the Stackable VLAN network. vlan-stack trunk Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network. C9000 Series Syntax vlan-stack trunk To remove a trunk port designation from the selected interface, use the no vlan-stack trunk command. Defaults Not configured. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Netowrking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. VLAN Stacking 1914