Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1412

Version 9.5(0.1) 8.3.19.0 8.3.12.0 8.4.1.1 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the E-Series ExaScale. Usage Information The following describes the show ip pim snooping neighbor commands shown in the following example. Field Neighbor address Interface Uptime/expires Ver Description Displays the IP address of the neighbor learned through PIM-SM snooping. Displays the VLAN ID number and slot/port on which the PIM-SM-enabled neighbor was discovered. Displays the amount of time the neighbor has been up then the amount of time until the neighbor is removed from the multicast routing table (that is, until the neighbor hold time expires). Displays the PIM version number: • v2 = PIM version 2 DR prio/Mode Displays the Designated Router priority and the mode: • 1 = default Designated Router priority (use the ip pim dr-priority command) • DR = Designated Router • S = Sparse mode Example Dell#show ip pim snooping neighbor Neighbor Interface Uptime/Expires Ver Address 165.87.32.2 Vl 2 [Te 1/13 ] 00:04:03/00:01:42 v2 165.87.32.10 Vl 2 [Te 1/11 ] 00:00:46/00:01:29 v2 165.87.32.12 Vl 2 [Te 41/20 ] 00:00:51/00:01:24 v2 DR Prio 1 0 0 show ip pim interface View information on the interfaces with IP PIM enabled. C9000 Series Syntax Command Modes show ip pim interface • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. PIM-Sparse Mode (PIM-SM) 1412