Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 89

Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.5.1.0 8.2.1.0 8.1.1.0 7.6.1.0 7.5.1.0 E-Series Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4820T. Added support for 4-port 40G line cards on ExaScale. Increased number of VLANs on ExaScale to 4094 (was 2094). Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Original command line Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the access conditions for the designated line. C9000 Series Syntax Parameters line {console 0 | vty number [end-number]} console 0 vty number end-number Enter the keyword console 0 to configure the console port. The console option for the S-Series is . Enter the keyword vty then a number from 0 to 9 to configure a virtual terminal line for Telnet sessions. The system supports 10 Telnet sessions. (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure. You can configure multiple lines at one time. Defaults Not configured Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Control and Monitoring 89