Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1810

day Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time month day year. year Enter a four-digit number as the year. The range is from 1993 to 2035. Defaults Not configured. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information You can change the order of the month and day parameters to enter the time and date as time day month year. You cannot delete the software clock. The software clock runs only when the software is up. The clock restarts, based on the hardware clock, when the switch reboots. Dell Networking recommends using an outside time source, such as NTP, to ensure accurate time on the switch. Example Dell#clock set 16:20:00 19 may 2001 Dell# clock summer-time date Set a date (and time zone) on which to convert the switch to daylight saving time on a one-time basis. C9000 Series Syntax clock summer-time time-zone date start-month start-day start-year start-time end-month end-day end-year end-time [offset] To delete a daylight saving time zone configuration, use the no clock summer-time command. Parameters time-zone start-month Enter the three-letter name for the time zone. This name is displayed in the show clock output. Enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to time day month year. System Time and Date 1810