Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1746

Related Commands logging - enables logging to the Syslog server. logging synchronous Synchronize unsolicited messages and output. C9000 Series Syntax logging synchronous [level level | all] [limit number-of-buffers] To disable message synchronization, use the no logging synchronous [level level | all] [limit number-of-buffers] command. Parameters all level level all limit number-ofbuffers Enter the keyword all to ensure that all levels are printed asynchronously. Enter the keyword level then a number as the severity level. A high number indicates a low severity level and vice versa. The range is from 0 to 7. The default is 2. Enter the keyword all to turn off all. Enter the keyword limit then the number of buffers to be queued for the terminal after which new messages are dropped. The range is from 20 to 300. The default is 20. Defaults Disabled. If enabled without the level or number-of-buffers options specified, level = 2 and number-of-buffers = 20 are the defaults. Command Modes LINE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information When you enable logging synchronous, unsolicited messages appear between software prompts and outputs. Only the messages with a severity at or below the set level are sent to the console. If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on that terminal line. Messages may continue to appear on other terminal lines. Simple Network Management Protocol (SNMP) and Syslog 1746