Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 779

Parameters half full Enter the keyword half to set the Management interface to transmit only in one direction. Enter the keyword full to set the Management interface to transmit in both directions. Defaults Not configured. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.11.1 8.1.1.0 7.5.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the C-Series. Documentation modified - added Management to distinguish from duplex (10/100 Interfaces). Usage Information This command applies to the Management interface on the route processor modules (RPMs) and port extender (PE) ports. Related Commands • interface ManagementEthernet - configures the Management port on the system (either the Primary or Standby RPM). • management route - configures a static route that points to the Management interface or a forwarding router. • speed (Management interface) - sets the speed on the Management interface. flowcontrol Enable and disable link-level flow control (802.3x pause frames) on an interface and (optionally) configure buffer thresholds for pause and offset frame transmission. C9000 Series Syntax Parameters flowcontrol rx {off | on} tx {off | on} [pause-threshold {1-12480}] [resumeoffset {1-12480}] rx on rx off Enter the keywords rx on to process the received flow control frames on this port. Enter the keywords rx off to ignore the received flow control frames on this port. Interfaces 779