Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1019

destination-port number Enter the keywords destination-port then the destination port number. Command Modes EXEC Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.10.0 8.5.1.0 8.1.1.0 7.9.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for 4-port 40G line cards on ExaScale. Introduced on the E-Series ExaScale. Introduced VRF on the E-Series. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information This command provides egress port information for a given IP flow. This information is useful in identifying which interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed packed only. For switched packets, use the show port-channel-flow command. The show ip flow command does not compute the egress port information when load-balance mac hashing is also configured due to insufficient information (the egress MAC is not available). S-Series produces the following error message: %Error: Unable to read IP route table. Example Dell#show ip flow interface Te 1/8 189.1.1.1 63.0.0.1 protocol tcp source-port 7898 destination-port 8 flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976 Ingress interface:Te 1/20 Egress interface:Te 1/14 to 1.7.1.2[CAM hit 103710] unfragmented packet Te 1/10 to 1.2.1.2[CAM hit 103710] fragmented packet IPv4 Routing 1019