Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 954

show ip igmp interface View information on the interfaces participating in IGMP. C9000 Series Syntax Parameters show ip igmp interface [interface] interface (OPTIONAL) Enter the interface type and slot/port information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383. • For a port channel interface, enter the keywords port-channel then a number. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 E-Series legacy command. Description Introduced on the C9010. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information IGMP commands accept only non-VLAN interfaces - specifying VLAN does not yield results. The show ip igmp interface command does not display information corresponding to the loopback interfaces. Example Dell#show ip igmp interface GigabitEthernet 0/0 is down, line protocol is down Internet protocol processing disabled GigabitEthernet 0/5 is down, line protocol is down Internet protocol processing disabled GigabitEthernet 0/6 is down, line protocol is down Internet Group Management Protocol (IGMP) 954