Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1401

Defaults as above Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 8.2.1.0 7.6.1.0 Description Introduced on the C9010. Introduced on the E-Series ExaScale. Added the ipv6 option for the E-Series. Introduced on the E-Series. Usage Information When an NSF-capable router comes up, it announces the graceful restart capability and restart duration as a Hello option. The receiving router notes the Hello option. Routers not NSF-capable discard the unknown Hello option and adjacency is not affected. When an NSF-capable router goes down, the neighboring PIM speaker preserves the states and continues the forwarding of multicast traffic while the neighbor router restarts. ip pim join-filter Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group. C9000 Series Syntax ip pim join-filter ext-access-list To remove the access list, use the no ip pim join-filter ext-access-list command. Parameters ext-access-list Enter the name of an extended access list. Defaults none Command Modes INTERFACE INTERFACE (BATCH Mode) Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.8(0.0) Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. PIM-Sparse Mode (PIM-SM) 1401