Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1062

ipv6 address eui64 Configure IPv6 EUI64 address configuration on the interface. C9000 Series Syntax ipv6 address {ipv6-address prefix-length} eui64 To disable IPv6 EUI64 address autoconfiguration, use the no ipv6 address {ipv6-address prefix-length} eui64 command. Parameters ipv6-address prefix-length Enter the IPv6 prefix in the x:x:x:x::x format then the prefix length in the /x format. The range is from /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 9.2(0.0) Description Introduced on the C9010. Introduced on the Z9500. Introduced. Usage Information This command allows you to create an EUI64 address based on the specified prefix and MAC address only. Prefixes may be configured on the interface using the ipv6 nd prefix command without creating an EUI64 address. Example Dell(conf)#int ten 0/4 Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64 Dell(conf)#int ten 0/6 Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64 ipv6 control-plane icmp error-rate-limit Configure the maximum number of ICMP error packets generated and sent in one second. C9000 Series Syntax ipv6 control-plane icmp error-rate-limit {1-200} To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command. IPv6 Basics 1062