Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 68

ipv4-fib interval time-inminutes Enter the keyword ipv4-fib to designate the CAM audit on the IPv4 forwarding entries. Enter the keyword interval followed by the frequency in minutes of the CAM audit. Range: 5 to 1440 minutes (24 hours). Default: 60 minutes. Defaults Disabled Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 7.4.1.0 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the E-Series. Usage Information Enables periodic audits of the software and hardware copies of the IPv4 forwarding table. Use this command in Configuration Terminal Batch mode to enable the audits in the chassis connected in a dualhoming setup. clear alarms Clear alarms on the system. C9000 Series Syntax clear alarms Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.6.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Control and Monitoring 68