Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1803

time-zone Configure the time zone for contacting the person. Syntax time-zone zone +-HH:MM[start-time HH:MM] [end-time HH:MM] To remove the time zone, use the no time-zone [zone | start-time | end-time] command. Parameters zone +-HH:MM Enter the keyword zone then a time difference from GMT expressed as HH:MM. This number may be preceded by either a + or - sign. start-time HH:MM Enter the keywords start-time then a starting time expressed as HH:MM. Use the 24-hour clock format. stop-time HH:MM Enter the keywords stop-time then a stopping time expressed as HH:MM. Use the 24-hour clock format. Command Modes SUPPORTASSIST PERSON Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.9(0.0) Description Introduced on the C9010, Z9100-ON, S6100-ON, and S3100 series. Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000-ON, Z9500, MXL. Usage Information This command is optional for SupportAssist service configuration. SupportAssist Server Commands Dell Networking OS supports the following SupportAssist Server mode commands. proxy-ip-address Configure a proxy for reaching the SupportAssist remote server. Syntax proxy-ip-address {ipv4-address | ipv6-address} port port-number [ username userid password [encryption-type] password ] To remove the proxy, use the no proxy-ip-address command. Parameters ipv4-address ipv6-address Enter the IP address of the proxy server in a dotted decimal format (A.B.C.D). Enter the IPv6 address of the proxy server in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. NOTE: To use the IPv6 address, the Open Automation package should also support IPv6 communications. For this purpose, SupportAssist requires Dell Networking Open Automation 9.10(0.0) package or later. SupportAssist 1803