Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 126

show processes ipc Display the IPC messaging used internally between Dell Networking OS processes. C9000 Series Syntax Parameters show processes ipc [recv-stats | send-stats] [cp | rp | lp | pe {slot-id | all}] recv-stats send-stats cp rp lp slot-id pe pe-id Enter the keyword recv-stats to display information on IPC receiver-side messages. Enter the keyword send-stats to display information on IPC sender-side messages. Enter the keyword cp to view IPC message statistics on the Control Processor CPU. Enter the keyword rp to view IPC message statistics on the Route Processor CPU. Enter the slot ID of the line card for which you want to view IPC message statistics. The range of switch slot IDs is from 0 to 11. Enter linecard all to view IPC statistics for all line cards. Enter the keyword pe to view IPC message statistics on the port extender (PE) .The PE ID range is from 0 to 255. NOTE: The pe option is only visible when the extended bridge feature is enabled. Defaults Display IPC message statistics on all switch CPUs: Control Processor, Route Processor, and line cards. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.1.1.0 7.6.1.0 7.5.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series and E-Series. Control and Monitoring 126