Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 205

Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.4.2.1 Description Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the C-Series and S-Series. Usage Information The prerequisites for enabling MAB-only authentication on a port are: • Enable 802.1X authentication globally on the switch and on the port (the dot1x authentication command). • Enable MAC authentication bypass on the port (the dot1x mac-auth-bypass command). In MAB-only authentication mode, a port authenticates using the host MAC address even though 802.1x authentication is enabled. If the MAB-only authentication fails, the host is placed in the guest VLAN (if configured). To disable MAB-only authentication on a port, enter the no dot1x auth-type mab-only command. Use this command in Interface Batch Mode to authenticate a device with MAB in a dual-homing setup. Related Commands dot1x mac-auth-bypass dot1x authentication (Configuration) Enable dot1x globally. Enable dot1x both globally and at the interface level. C9000 Series Syntax dot1x authentication To disable dot1x globally, use the no dot1x authentication command. Defaults Disabled Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. 802.1X 205