Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 1162

The multicast commands are supported by Dell Networking operating system. This chapter contains the following sections: • IPv4 Multicast Commands NOTE: Dell Networking OS supports Multicast routing only on default VRFs . 32 Multicast IPv4 Multicast Commands The following section contains the IPv4 multicast commands. clear ip mroute Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base, use the clear ip pim tib command. C9000 Series Syntax Parameters clear ip mroute {group-address [source-address] | * | snooping} group-address [source-address] * snooping Enter the multicast group address and source address (if desired), in dotted decimal format, to clear information on a specific group. Enter * to clear all multicast routes. Enter the keyword snooping to delete multicast snooping route table entries. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2.(0.0) 9.0.2.0 8.3.19.0 8.3.7.0 7.8.1.0 Description Introduced on the C9010. Added support for keyword snooping on the Z9000, S4810, and S4820T. Introduced on the S6000. Introduced on the S4820T. Introduced on the S4810. Introduced on the C-Series. Multicast 1162