Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 105

Port Switching Method This setting is used to select when port switching takes place. • Switch at End of Job: The port changes to auto selection when printing ends. • Switch after I/O Timeout: When the time set in "I/O Timeout" (page 102) elapses, the port changes to auto selection. Select one of the keys and touch the [OK] key. The following two print ports are available on the machine: • USB port • Network port Color Adjustments This is used to adjust grayscale and color balance. Touch [Printer Settings] key and touch the [Color Adjustments] key and configure the settings. Auto Color Calibration This is used to perform automatic color correction when the color in color copies is off. The machine prints a test patch, the test patch is scanned, and the color is automatically corrected. System Settings Auto Color Calibration OK Use 11"x17" or A3 paper for this adjustment. Press [Execute] to print the test patch. • Before executing Auto Color Calibration, check to see if the registration adjustment is correct. If the registration adjustment is not correct, perform "Registration Adjustment" (page 95). • If the color is still off after performing Auto Color Calibration, repeating Auto Color Calibration once again may improve the color. Execute After the [Execute] key is touched and a test patch is printed, a message appears prompting you to begin automatic calibration. Place the test patch on the document glass as shown below so that the narrow line of one-side of the paper is on the left and touch the [Execute] key. Narrow line Lay copy paper (about five sheets) that is the same size as the test patch on top of the placed test patch, and gently close the automatic document feeder. 103