Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 475

INFORMATION APPEARING IN THE RESULT COLUMN Error types and other information are printed in the result column of the report. Check the transaction result in the result column and take appropriate action if the result is an error. Examples of messages that are printed in the result column Message OK G3 ECM SG3 FW. NO RESPONSE BUSY CANCEL MEMORY OVER MEM.FULL LENGTH OVER ORIGINAL ERROR PASS# NG NO RX POLL RX POLL FAIL NO F-CODE POLL RX POLL# NG F POLL PASS# NG BOX NO. NG F PASS# NG RX NO F-CODE POLL NO F FUNC NO F-CODE M. BOX: [xxxxxx] NG xx (xxxx) (1) (2) REJECTED Explanation The transaction was completed normally. Communication took place in G3 mode. Communication took place in G3 ECM mode. Communication took place in Super G3 mode. The received data was forwarded. No response from the receiving party. Transmission was not possible because the other party was already using the line. The transmission was cancelled while in progress. The memory became full during quick on-line transmission. The memory became full during reception. The transmitted fax was over 1.5 m (59") long and therefore could not be received. Direct transmission or manual transmission was not successful because a misfeed occurred. The connection was broken because the polling passcode was not correct. The machine that was polled does not have a polling function. The other machine refused the polling operation, or your machine broke the connection when polled because no data was in memory. The other machine refused an F-code polling operation, or your machine broke the connection when polled because no data was in its F-code memory polling box. The connection was broken because the sub-address for F-code polling memory was not valid. The connection was broken because the passcode for F-code polling memory was not valid. Your machine broke the connection because the specified sub-address for an F-code memory box does not exist. Your machine broke the connection because the other machine sent an incorrect passcode for F-code communication. F-code polling was attempted, however, the other machine did not have an F-code polling memory box. F-code communication was attempted, however, the other machine does not support F-code communication. F-code communication was refused by the other machine because of an incorrect sub-address or other reason. Data was received to a confidential or relay broadcast memory box, or data was sent from a memory polling box. The name of the memory box appears in [xxxxxx], and the type of F-code operation (relay request reception, polling memory transmission, or confidential reception) appears in . The communication handshake signals or image signals were distorted due to line conditions or other reasons, and communication was not successful. (1) First two digits of communication error number: Error code from 00 to 99. (2) Last four digits of communication error number: Code for use by service technicians. A fax was sent from a party from which reception is blocked. 59