Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 805

Paper Select 81/2x11 81/2x11R 8 81/2x14 11x17 Plain Plain Plain Plain OK 81/2x11 Recycled (1) (2) Select the bypass tray. (1) Touch the paper size key of the bypass tray. (2) Touch the [OK] key. Do not place heavy objects on the bypass tray or press down on the tray. IMPORTANT POINTS WHEN USING THE BYPASS TRAY • When using plain paper other than SHARP standard paper or special types of paper other than SHARP-recommended transparency film, or are printing on the reverse side of previously used paper, the paper must be loaded one sheet at a time. Loading more than one sheet at a time will cause misfeeds. • Before loading paper, straighten any curling in the paper. • When adding paper, remove any paper remaining in the tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result. • When using glossy paper, set the paper type to [Heavy Paper]. This will bring out the glossy quality of the paper. Inserting paper 7-1/4" x 10-1/2", A5 or less size paper must be inserted in the horizontal orientation as shown at left. Inserting tab paper When copying on tab paper, orient the paper so that the side with the tabs enters the machine last. The bottom side of the inserted paper will be printed on. Place the tab paper and original as shown below. Original Tab paper Copy Automatic document feeder Document glass Leading edge 1 of original 2 3 4 5 5 4 1 Paper feed 3 2 direction 1 2 3 4 5 When copying onto tab paper, insert the tab paper with the side to be copied on face down in the bypass tray. Face down Use only tab paper that is made of paper. Tab sheets made of film or other material cannot be used. 30