Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 121

Disabling of Tray Setting This setting is used to prohibit tray settings. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Finisher (When a saddle stitch finisher or finisher is installed.) This setting is disable the saddle stitch finisher or finisher, such as when the unit malfunctions. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Offset This setting is used to disable the offset function. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Stapler (When a saddle stitch finisher or finisher is installed.) This setting is used to prohibit stapling, such as when the stapler unit of the finisher or the saddle stitch finisher malfunctions. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Punch (When a punch module is installed.) This setting is used to prohibit punching, such as when the punch module of the finisher or the saddle stitch finisher malfunctions. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Color Mode (When a color-related problem has occurred.) When a color-related problem has occurred and printing is not possible, the use of color mode can be prohibited on an emergency basis and only black and white printing allowed. To enable this setting, select the checkbox and touch the [OK] key. This function is only for use as an emergency measure. Once this setting is enabled, only a service technician can cancel the setting. Promptly contact your dealer or nearest SHARP service department to have a service technician cancel the setting and resolve the color-related problem. Disabling of Master Machine Mode This prohibits the use of the machine as a master machine for tandem printing. To enable this setting, select the checkbox and touch the [OK] key. (Normally this setting is not necessary.) Disabling of Slave Machine Mode This prohibits the use of the machine as a slave machine for tandem printing. To enable this setting, select the checkbox and touch the [OK] key. (Normally this setting is not necessary.) Copy Settings Disable Copy in Different Size/Direction This is used to prohibit copying when the paper and original are placed in different orientations or the proper size of paper is not loaded. To enable this setting, select the checkbox and touch the [OK] key. This setting is only effective when "Rotation Copy Setting" (page 96) is disabled. Disabling Deletion of Job Programs This is used to prohibit the deletion and changing of copy settings stored in job programs. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Bypass-Tray in Duplex Copy This is used to prohibit the use of the bypass tray when making two-sided copies. The bypass tray is often used to feed label sheets, transparency film, and other special papers for which two-sided copying is prohibited. If one of these special papers enters the reversing unit, a misfeed or damage to the unit may result. If special papers for which two-sided copying is prohibited are often used, it is recommended that you enable this setting. To enable this setting, select the checkbox and touch the [OK] key. 119