Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 99
Disabling of Auto Paper Selection, Disabling Deletion of Job
View all Sharp MX 4501N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Initial Margin Shift Setting The default setting for margin shift can be set from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm). Specify the default settings for "Side 1" (front) and "Side 2" (back) with the keys and touch the [OK] key. (To make the number change quickly, keep your finger on the or key.) Initial Tab Copy Setting This is used to set the default image shift width (tab width) for tab copying. The default width can be set from 0" (0 mm) to 5/8" (20 mm) in increments of 1/8" (1 mm). Erase Width Adjustment The default setting for erase width can be set from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm). Specify the default settings for the "Edge" and "Center" with the keys and touch the [OK] key. (To make the number change quickly, keep your finger on the or key.) Specify the desired number with the keys and touch the [OK] key. (To make the number change quickly, keep your finger on the or key.) Card Shot Settings This program is used to set the default original size for the card shot function. Both the X (horizontal) and Y (vertical) dimensions of the original can be set from 1" (25 mm) to 8-1/2" (210 mm) in increments of 1/8" (1 mm). System Settings Card Shot Settings OK Set the default original size for card shot. X 33/8 (1 81/2) inch Y 21/8 (1 81/2) inch Fit to Page Select the [X] key or the [Y] key, specify the dimension with the keys, and touch the [OK] key. If you wish to fit the image to the paper, select the [Fit to Page] key in the card shot settings screen and touch the [OK] key. Automatic Saddle Stitch (When a saddle stitch finisher is installed.) This is used to have saddle stitch stapling take place automatically when the pamphlet copy function is used. To enable this setting, select the checkbox and touch the [OK] key. Disabling Deletion of Job Programs This is used to prohibit the deletion and changing of copy settings stored in job programs. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Bypass-Tray in Duplex Copy This is used to prohibit the use of the bypass tray when making two-sided copies. The bypass tray is often used to feed label sheets, transparency film, and other special papers for which two-sided copying is prohibited. If one of these special papers enters the reversing unit, a misfeed or damage to the unit may result. If special papers for which two-sided copying is prohibited are often used, it is recommended that you enable this setting. To enable this setting, select the checkbox and touch the [OK] key. Disabling of Auto Paper Selection This setting is used to disable the Auto Paper Selection function. When this setting is enabled, automatic selection of paper that is the same size as the original on the document glass or in the automatic document feeder does not take place. To enable this setting, select the checkbox and touch the [OK] key. 97