Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 507

Ready to send. Fax Mode Switch Image Settings Scan 81/2x11 Memory TX Direct TX Auto Reception Fax Memory:100% Send Auto Speaker (1) Resend Address Book Sub Address Special Modes File Quick File 4 (3) (2) To AAA AAA Cc BBB BBB Condition Settings 1/1 Address Review CCC CCC DDD DDD Global EEE EEE FFF FFF Sub Address Frequent Use ABCD EFGHI JKLMN OPQRST UVWXYZ Sort Address Enter the destination fax number. (1) Touch the [Address Book] key. (2) Touch the one-touch key of the desired destination. (3) Touch the [To] key. ☞ CALLING UP A FAX NUMBER FROM THE ADDRESS BOOK (page 36) If the fax number of the transmitting machine is not stored in the Address Book, enter the fax number with the numeric keys. ☞ ENTERING A FAX NUMBER WITH THE NUMERIC KEYS (page 35) You can touch the key to display a list of the selected special mode settings. To return to the previous screen after checking the settings, touch the [OK] key. 5 To cancel scanning... Press the [STOP] key ( ). Press the [BLACK & WHITE START] key ( ) to scan the first set. Insert the next set of originals and press the [BLACK & WHITE START] key ( ). Place the originals face up. Insert the originals all the way into 101 the document feeder tray. The stack must not be higher than 6 the indicator line. Repeat until all sets of originals have been scanned. If no action is taken for one minute after the final original is scanned, scanning automatically ends and the transmission is entered in the job queue. Place next original. (Pg.No.x) Press [Start]. 7 When finished, press [Read-End] Read-End Touch the [Read-End] key. • If the memory becomes full during scanning, a message will appear and the transmission will be canceled. • This function cannot be used in combination with the following functions: Dual Page Scan, Card Shot To cancel the job build function.... Touch the [Job Build] key in the screen of step 3 so that it is not highlighted. 91