Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 346
System Settings Administrator: Transaction Report Print Select Setting
View all Sharp MX 4501N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 346 highlights
Press the [BLACK & WHITE START] key ( ). Scanning begins. • If you inserted the original pages in the document feeder tray, all pages are scanned. A beep will sound to indicate that scanning is finished. • If you are scanning the original on the document glass, scan 8 each page one page at a time. When scanning finishes, place the next original and press the [BLACK & WHITE START] key ( ). Repeat until all pages have been scanned and then press the [Read-End] key. A beep will sound to indicate that scanning is finished. To cancel scanning... Press the [STOP] key ( ) to cancel the operation. For a broadcast transmission, changes to the transaction report print conditions apply to all destinations. • System Settings (Administrator): Transaction Report Print Select Setting This is used to set the conditions for printing transaction reports. The factory default settings for printing are indicated by below. Single Sending: Print Out All Report/ Print Out Error Report Only /No Printed Report Broadcasting: Print Out All Report /Print Out Error Report Only/No Printed Report Receiving: Print Out All Report/Print Out Error Report Only/ No Printed Report • System Settings (Administrator): Original Print on Transaction Report This is used to have part of the transmitted original printed on the transaction report. 123