Sharp MX 4501N MX-2300N MX-2700N MX-3500N MX-3501N MX-4500N MX-4501N - Page 820

SADDLE STITCH FINISHER The saddle stitch finisher is equipped with the offset function that offsets each set of output from the previous set, the staple sort function that staples each set of output, and the saddle stitch function that automatically staples and folds each set of output at the centerline. An optional hole punching unit can also be installed to punch holes in output. PART NAMES (1) (4) (2) (5) (6) (3) (7) (1) Stapler compiler This temporarily stacks paper to be stapled. (2) Output tray Stapled and offset output is delivered to this tray. The tray is slidable. Extend the tray for large output (12" x 18", 11" x 17", 8-1/2" x 14", 8-1/2" x 13", A3W, A3 and B4 sizes). (3) Saddle stitch tray Stapled and folded output is delivered to this tray. (4) Top cover Open this cover to remove a paper misfeed. (5) Lever To remove a staple jam or paper misfeed, pull this lever and slide the saddle stitch finisher to the left until it stops. (6) Stapler section Open the front cover and pull out this section to replace the staple cartridge or remove a staple jam. (7) Front cover Open this cover to replace the staple cartridge or remove a staple jam. • A paper pass unit is required to install a saddle stitch finisher. • Do not place heavy objects on the saddle stitch finisher or press down on the saddle stitch finisher. • Use caution when you turn on the power and when printing is taking place, as the tray may move up and down. • A saddle stitch finisher and a finisher cannot be installed simultaneously. SUPPLIES The saddle stitch finisher requires the following staple cartridge: • Staple cartridge (approx. 5000 staples per cartridge x 3 cartridges) AR-SC2 45