Dell C1048P Port Extender Networking Command-Line Reference Guide for the C900 - Page 100

validate-reply outgoinginterface pattern pattern sweep-min-size sweep-max-size sweep-interval ointerface • Y: Do set "don't fragment" bit Default is No. (IPv4 only) Enter Y or N for reply validation. • N: Do not validate reply data. • Y: Do validate reply data. Default is No. (IPv6 link-local address) Enter the outgoing interface for ping packets to a destination link-local address. (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default: 0xABCD. Enter the minimum size of datagram in sweep range. The range is from 52 to 15359 bytes. Enter the maximum size of datagram in sweep range. The range is from 53 to 15359 bytes. Enter the incremental value for sweep size. The range is from 1 to 15308 seconds. (IPv4 only) Enter the outgoing interface for multicast packets. Enter the IP address in A.B.C.D format. • For a Port Channel, enter the keyword port-channel then a number. The range is from 1 to 128. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. • For a VLAN interface, enter the keyword vlan then a number from 1 to 4094. Defaults Command Modes none • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.9(0.0) 9.2(1.0) Description Introduced on the C9010. Introduced on the Z9500. 100 Control and Monitoring